Tags
solarcube
4 articles

AEG SolarCube Pro (AS-BBL08) after the firmware update: why it drained, and how to really switch it off
In September, the AEG SolarCube Pro from our review drained while it was switched off, and the firmware update broke off every time at about 21%. HYXi, the manufacturer, confirmed two faults in the old firmware, and neither of them was in the hardware. On the new firmware, the same unit stood off the grid for 23 hours with the button off, and went from 49% to 49%. Here is what happened, why, how to really switch it off, and three corrections to the review and the update.
- GuideGuide
AEG SolarCube Pro error 170305110: what “Head unit undervoltage, level-3 fault” means
Error 170305110, Head unit undervoltage, level-3 fault, means the battery of the AEG SolarCube Pro is discharged too deeply and the battery management system has locked it. For days the app then says Battery Force Charging Mode while 2 to 6 W goes in. Our unit drained itself off the grid, sat locked for 4 days and 5 hours after it was plugged back in, and came out on its own. What each message means, why it drains while it looks switched off, and what does and does not help.
energie17 min read
ReviewAEG SolarCube Pro review (AS-BBL08-6K): what comes out, and where the rest goes
The AEG SolarCube Pro costs € 1,799 and promises 6.0 kWh usable and a single efficiency figure. We hooked it up to our techbench for two days, walked the whole discharge curve by hand and closed the cycle: 1,165 Wh went in and 947 Wh came out. After the test, off the grid, it drained itself until the battery management system locked it out, and it only came out of that by itself 4 days and 5 hours later. Here is the full file behind the video: every figure with its origin and grid setting, the registers we mapped ourselves, the places where the product sheets contradict each other, and the fifteen things I do not know yet.
81.29 % efficiency (800 W)own measurement
energie60 min read- ResearchResearch
AEG SolarCube Pro Modbus registers (AS-BBL08 / HYXi HALO): what works and what only stores
The AEG SolarCube Pro (AS-BBL08) has an RS485 port that speaks Modbus, locally and without an account, but we found no register document that matches this unit. This is the register map we built ourselves and checked register by register against the unit: how to connect, which registers work, how to control charge and discharge, which registers store a value and do nothing, and which block you never write. The whole map is also available as a CSV download.
energie23 min read